Hammerite Direct To Rust Metal Paint can be painted directly onto rusty surfaces and, thanks to its special 3 in 1 formula, there is no need to use a primer or undercoat - saving you precious time! Hammerite forms a superior barrier that not only seals out moisture, but also gives long lasting protection, both inside and outside.

Brand Name	Hammerite
Colour	Black
Manufacturer Model No	HMMHFBLAERO
Type	Aerosol
Protects From	Moisture
Paint Type	Direct to Rust Aerosol
Size (ml)	400

The Hammerite Metal Smooth Paint is specially formulated to perform as primer, undercoat and topcoat in one. This paint forms a tough barrier which repels moisture and provides long lasting protection. Corrosion resistant with a high gloss colour retention. Can be applied directly onto rusty metal, just use a wire brush to remove loose paint etc. to leave a dry dirt-free surface.

Brand Name	Hammerite
Colour	Black
Material	Metal
Type	Spray paints
Protects From	rust
Finish	Hammered
Size	0.4 L
Application Method	Spray
Interior or Exterior Use	Exterior
Coverage per Litre	0.8 m2
Drying Time	1-2 hours
Drying time between coats	4 hours
Washable	Yes
Clean equipment with	Water
Suitable for	Metal
VOC Level	Very high

This Black metal spray paint has been specially designed to give a durable and long-lasting hammered effect finish on a range of surfaces. Simply spray and leave for 4-6 hours to dry - a great way to give the surfaces additional protection. Covers 5m² per litre on average.

Brand Name	Hammerite
Colour	Black
Material	Metal
Manufacturer Model No	5011867201139
Type	Spray paint
Application method	Spray
Base	Solvent-based
Coverage	5m
Drying time	4-6 h
Location	Interior
Volume	400ml
Product code	5011867201139

Brand Name	Hammerite
Material	Metal
Type	Paint
Protects From	Rust
Product Type	Metallic Paint
Short Description	Hammerite:Ultimate metal protection.
Drying time (recoat)	15 minutes
Drying time (touch dry)	1-2 hours
Suitable Surface	Metal
Coverage	Aerosol - 400ml covers up to 0.5m²
General No. of Coats	3
Application description	Store aerosol at room temperature for 2 hours prior to use. Shake can vigorously, in a vertical motion, until the agitator ball is heard and then for a further 3 minutes .Apply light even coats, from a distance of approximately 15cm (6 inches) and keep the aerosol moving. Do NOT concentrate spray in one spot. Apply 3-4 coats for maximum protection and allow 15 minutes between coats. Between coats invert can and spray for 2 seconds to avoid blockages